Additives

A combination of agents, developed specifically for late model hybrid engines. Removes deposits in the fuel system and protects against corrosion. Stabilizes the fuel and protects against aging and oxidation. Diminished fuel degradation allows better...

LIQUI MOLY recommends adding Motorbike Radiator Cleaner to the cooling water if problems arise or before changing the coolant. Depending on the level of contamination, run the engine at operating temperature for 10-30 minutes. Drain the cleaner and flush...

Removes deposits from the fuel system, valves, spark plugs and the combustion chamber while preventing new deposit formation. Improves engine performance and lowers emissions. Provides corrosion protection throughout and prevents carburetor icing...

A combination of additives to clean and maintain the diesel fuel system. Prevents corrosion, increases lubrication thus reduces fuel pump and injector wear. Increases Cetane value for improved engine performance, easier starting and lower emissions...

Add contents to the cooling water. Turn the heating to maximum and let the engine run on idle for 10 - 30 minutes depending on the degree of contamination. Drain the coolant and flush the cooling system with water. Fill the cooling system according to...

To prepare, attach tube with nozzle. To gain access, remove hose or pipe immediately before throttle housing. The engine needs to run to perform cleaning. If unable to start engine, disconnect air mass sensor connector while the ignition switch is in off...

For all gasoline engines. Suitable for standard and high-octane gas, leaded and unleaded. 150 ml is sufficient for up to 75 liters (20 gal.)of fuel.Minimum fuel filling of 25 liters (7 gal.) is requested for optimum product performance.Product...

The unique combination of proven PEA technology and the latest additive generation achieves maximum cleaning performance in the combustion chamber, in and around the injector tip and in the entire fuel system. Furthermore, DIJectron stops the formation...

Provides initial lubrication of new or replaced turbochargers to prevent damage due to oil starvation. Damage to turbocharger may occur within seconds of engine start if not lubricated properly. Pro-Line Turbocharger additive will provide needed...

One 500 ml can is sufficient for up to 5 liters(1.3 gal.) of oil. Add Pro-Line Engine Flush to the engine oil at operating temperature before changing the oil. After adding the product allow the engine to idle for 10 to 15 minutes depending on the degree...

To be added directly into the fuel tank. As a preventive measure, add during each inspection, after repairs on the fuel system and after each Jet-Clean cleaning operation. The product mixes with the fuel automatically. Minimum fuel filling of 25 liters...

High-tech fuel additive, developed specifically for improved throttle response under partial engine load. Optimizes fuel atomization and combustion, cleans fuel system while providing maximum engine performance and efficiency.Product Specifications...